Instructions for use
Plug into 230V AC mains outlet and select desired speed.
0 – Off
1 – Low Speed
2 – High Speed
Pressing the Oscillation knob located on the top/back of the Motor Housing will cause the fan to
sweep back and forth. Lifting the oscillation knob will stop the sweeping motion of the fan.
The inclination of the fan head may be adjusted by loosening the tilt adjustment screw lifting the
Motor Housing Head to the position needed. Tighten the screw up when correct position is
found
NOTE:
This should only be done when the fan is switched off.
Cleaning and Maintenance
•
Switch off the power supply and pull out the plug from the mains socket before cleaning.
•
A soft dry cloth is usually adequate but can be moistened with mild detergent solution if
required.
•
Never clean the unit with solutions such as thinners and polishing powder etc.
U.K. PLUG WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BROWN
- LIVE (L)
BLUE
- NEUTRAL (N)
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
•
The BLUE wire is the NEUTRAL and must be connected to the terminal which is marked with the letter
N or coloured BLACK
•
The BROWN wire is the LIVE and must be connected to the terminal, which is marked with the letter L
or coloured RED.
Always ensure that the cord grip is positioned and securely fastened.
WARNING: ON NO ACCOUNT MUST EITHER THE LIVE OR NEUTRAL WIRES BE CONNECTED TO THE
EARTH TERMINAL
WIRING FOR A 13AMP PLUG
