To assemble to fan and grille
•
Place the Rear Grille onto the Motor Housing Top and align the Locating Pegs.
NOTE: The small screw hole should be at the bottom of the fan
•
Next place the Grille Retaining Ring onto the Motor Housing Top and turn to tighten and
secure.
•
Slide the Fan Blade over the motor shaft ensuring that it is firmly seated and fit the blade
retaining knob and turn anti-clockwise to tighten.
•
Loosen the nut on the back of the Front Grille and unscrew the screw from the front of the
Front Grille.
•
Open the 3 grill clamps on the front blade cover and fit the edge of the back cover into the
slot on the rim of the front cover, align screw holes, and close clamps.
•
Fit nut and screw and tighten.
Instructions for use
Plug into 230V AC mains outlet and select desired speed.
0 – Off
1 – Low Speed
2 – Medium Speed
3 – High Speed
Pressing the Oscillation knob located on the top/back of the Motor Housing will cause the fan to
sweep back and forth. Lifting the oscillation knob will stop the sweeping motion of the fan.
The inclination of the fan head may be adjusted by loosening the tilt adjustment screw lifting the
Motor Housing Head to the position needed. Tighten the screw up when correct position is
found
NOTE:
This should only be done when the fan is switched off.
Cleaning and Maintenance
•
Switch off the power supply and pull out the plug from the mains socket before cleaning.
•
A soft dry cloth is usually adequate but can be moistened with mild detergent solution if
required.
•
Never clean the unit with solutions such as thinners and polishing powder etc.
