INSTALLATION
Drill two holes on the wall allowing 1.8meters above the floor and 20cm from side walls. Be sure to make
the hole diameter is the same as the expanding screw pipe. Place the expanding screw pipe into the hole in
the wall and then fix two screws on the expanding pipe, keep the tips of the screws out approx. 10mm, and
hang up the heater. Ensure that the screws are strong enough. Screws and screw mounts are provided.
WARNING: DO NOT MOUNT DIRECTLY UNDER AN ELECTRICAL POWER SOCKET.
Please read these instructions carefully and keep for future reference.
USING THE HEATER
Before inserting the plug in electrical outlet, make sure that the correct voltage being used corresponds to
what is indicated on the rating label on the unit.
This instruction will apply to both the control panel on the heater and on the remote.
Plug the unit into the mains power supply, and then switch the ON the main power supply.