OVERVIEW OF GOLDAIR CONVECTOR HEATER
Your Goldair Convector Heater is equipped with three heat settings and a thermostat to ensure your precise
heating needs are met. In addition the heater has a fan boost option which assists with circulating warm air
through your room. To enable you to set the heater to come ON and OFF when you require it, the appliance
is fitted with a 24 hour mechanical timer.
OPERATING YOUR HEATER
Before operation place the product on a flat, stable, heat-resistant surface. Plug the power cord into a
standard 230/240 volt AC electrical outlet. The heater has three different settings:
• 0 - Off
• 1 - low heat
• 2 - medium heat
• 3 - high heat
Additional to the three heat settings there is a turbo fan with a separate On/Off switch located on the control
panel.
THERMOSTAT
Turn the thermostat knob until the maximum temperature is obtained on the graduated scale. When the
desired room temperature is reached, slowly turn the knob anti-clockwise until the heater turns off (you will
hear a click). The temperature will now remain constant, regulated by the thermostat.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase. (Refer to back of booklet).
Mode Switch
TIMER
•Set the MODE switch to the Timer position (this function can only be used once a heat level has been
selected (see thermostat, power settings).
•Turn the outer dial of the timer in a clockwise direction until the time of the day (24-hour clock) corresponds
with the triangular marking. One complete turn of the dial corresponds to 24 hours.
•There are 48 “riders”, positioned around the dial, each rider represents 30 minutes. When the “riders” are
pushed out the heater will turn on when they travel past the triangle marking on the casing. You need to
push out the riders to correspond with the time the heater is to turn on.
•If you would like to use the heater without the timer, set the mode switch to the “I” position to override
Heat setting
Turbo Fan
On/Off switch
Thermostat
24 Hour Timer
