ASSEMBLY
Remove the 3 screws from the bottom of the tower
Assembling your Fan
Always choose a safe location for the Fan, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the unit
before use. This appliance requires no installation, it should be used solely as
a portable appliance.
Assemble the base to the tower bottom. With the
tower on its side, align the base sockets onto the
tower
bottom
pins.
Tighten
the 3 screws
securely but do not over tighten.
Press the power cord securely into the line
recess.
REMOTE CONTROL
The remote control comes with a CR2025
lithium coin cell battery. To install, remove the
battery cover on the bottom of the remote
control. Remove any plastic protection from the
battery and place it in the remote with the + side
facing out. Then reposition the cover onto the
bottom of the remote.
The remote requires a line-of-sight path to allow
for the signal to be received by the unit. Position
the unit so the receiver lens is visible from the
remote control.
The symbols on the Remote correspond to the
symbols on the main unit.
If your remote no longer works, please try
replacing with a new CR2025 battery.
Pass the power cord through the two base
halves. Assemble the two base halves together.
Position the base half with the alignment pin,
over the other base half with the alignment
sockets. Press the two halves together until
flush.
