Operating your Fan
•
2 = Medium Speed
•
3 = High Speed
Fan control switch
The control switch positions are:
• 0 = OFF
• 1 = Low Speed
Check that the Fan control switch is set to the
off position before plugging into the mains
supply.
Place the Fan on a dry, level and sturdy
surface.
Plug the power cord into the socket, making
sure the speed control is at OFF position.
To operate the fan push down speed control
desired.
Adjust tilt by turning neck screw and tilting
body to the desired wind direction (i.e. either
upward or downward).
To activate the oscillation function, push
down the oscillation pin on the top of the
motor. The fan will then oscillate until the pin
is pulled back up.
Assembly
Firstly, loosen and remove the four screws
from the bars. Then interlock cross bars A
and B. Be sure to align the four holes in the
bars with those on the flange of the Outer
Tube. Secure the flange to the bars with the
four screws.
Loosen and remove the Height Adjustment
Collar from the top of the Inner Tube. Slide
the Base Decorative Cap down over the
assembly. Replace the Height Adjustment
Collar on top of the Inner Tube. Pull the Inner
Tube out from the Outer Tube to adjust the
tube to the desired height and tighten the
collar.
If necessary, slightly loosen the Set Screw by
turning it anticlockwise. Slide the Switch Box
down over the Inner Tube and tighten the Set
Screw. Make sure the Set Screw is tightly
secured.
Blade and grill
Unscrew the plastic mounting nut from the
front of the motor housing by rotating it
anticlockwise. Position the rear grill against
the front of the motor housing with the handle
at the top, ensure that the locating pegs on
the motor housing are engaged correctly in
the holes of the rear grill.
Tighten the Rear Grill Mounting Nut
clockwise; do not to over tighten.
Push the fan blade onto the motor shaft,
locating the slot at the back of the blade on
the drive pin that passes through the motor
shaft. Tighten the blade cap by turning it
anticlockwise.
Position the front grill against the rear grill so
that the holes in the rims that accept the
small nut and bolt are in line. Insert the bolt
through the holes and screw on the nut. Do
not fully tighten at the stage.
Push the grill retaining clips into position
ensuring that they engage correctly on the
rim of the grill.
Fully tighten the small nut and bolt that
passes through the rim of the grill.
