background image

Your  Goldair  product  has  been  inspected 
and tested and is guaranteed subject to the 
following  for  a  period  to  three  years  from 
the  date  of  purchase  against  defects  in 

workmanship  and  materials.  During  this 

period,  such  defects  will  be  rectified  by 
repair  or  replacement  of  the  product 
purchased.  Your  product  contains  no  user 
serviceable  components  and  this  warranty 
becomes invalid if in our opinion the product 
has  been  misused,  abused,  incorrectly 
installed,  tampered  with,  connected  to  an 
electrical supply not corresponding with the 
name  plate  specification,  or  subjected  to 
power  surges.  The  warranty  does  not 

include  any  labour  or  other  associated 

expense that may be involved in removal or 
installation of the product. Normal wear and 
tear is expressly excluded. 
If  your  Goldair  product  fails  to  operate 
satisfactorily,  please  return  it  to  the  retailer 
from  whom  it  was  purchased.  To  obtain  a 
repair  or  replacement  product  under  this 
warranty,  you  will  need  to  produce 
satisfactory  evidence  of  date  of  purchase. 
The  completed  warranty  and  purchase 
receipt must be presented with the product. 

The warranty should be filled out at the time 

of  purchase.  It  is  in  your  interest  to  make 
sure this is done. 

If  the  product  is  to  be  replaced  (cannot  be 
repaired)  then  that  replacement  will  be  of 
the  same  or  similar  product  or  accessory 
excluding  packaging,  instruction  card  etc. 

Where  a  replacement  product  is  supplied, 

this  shall  be  guaranteed  for  the  balance  of 
the original warranty period. 
Any model that is no longer available will be 
replaced  by  a  model  of  a  value  and  with 
such features as we consider appropriate in 
the 

circumstances. 

Goldair 

is 

not 

responsible  for  freight  forwarding  charges, 
losses or damage in transit. 
If  service  is  required  after  the  warranty 
period  has  expired,  the  product  should  be 

returned  to  a  qualified  electrical  technician. 

Service  outside  of  the  warranty  period  will 
be at your cost. 
Consumers Guarantee Act (1993). 
In 

accordance 

with 

the 

above 

act 

consumers 

are 

advised 

that: 

The 

manufacturer  does  not  undertake  that 
repair  facilities  and  parts  are  necessarily 
available for this product. 
If any of the provisions of the foregoing are 
contrary  to  any  relevant  legislation,  then 
that  provision  shall  be  deemed  to  be 

excluded  from  the  warranty  and  the  rest  of 

the provisions will continue to apply. 

Name ……………………………………………… 

Address …………………………………………… 

………………………………………………………. 

Suburb …………………………………………… 

 

Purchased 

from ………………………………… 

Date of purchase ………………………………… 

Name of product ………………………………… 

Model no ……………………………………………

 

  

IMPORTANT: Please retain this warranty card 

Three Year Warranty 

Summary of Contents for Ecosave GECO203







Reviews: