Sno-Konette
10
Models #1002S Series, 1003S Series, 1009S
13.
The shaver head set screws must be on the flat side of the motor shaft. Once aligned, fasten set
screws securely.
14.
Adjust the motor to realign with guide mark made on the cabinet in Step 3, then refasten motor
mounting bolts (if unit has a hopper support and guide, it must also be reinstalled). Check the
shaver head to make sure it is not rubbing against the back of the hopper and the blades are not
touching the pusher handle or sides of hopper; adjust as needed.
Note:
Replace any shims that were between the motor base and the mounting surface.
15.
Reinstall motor cover.
Height Gauge 1/32”
(thickness of a dime)
Set top of blade flush with
height gauge, as shown.
Blade Mounting Screw
Shaver Blade
Shaver Head
With a permanent marker, mark
shaft where shaver head stops.
Shaver Head
(2) Set Screws (fasten on
flat side of motor shaft)
With a permanent marker, mark
cabinet where motor sets.
Motor
Mounting
Bolts
Cut Away View of Shaver Head on Motor Shaft
General shaver image shown for reference only (models may vary).
Set Blade Height
Summary of Contents for Sno-Konette 1002-01-100
