A
LL
M
ODELS
#3005SS, #3008SS, 3015
Tornado
and
Whirlwind Floss Machine
4
ELECTRICAL REQUIREMENTS
The following power supply must be provided:
3005SS and 3008SS:
120 V~, 2400 W, 60 Hz
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
A certified electrician must furnish sufficient power for proper machine operation and install any supplied
receptacle. We recommend this equipment be on a dedicated and protected circuit. Failure to wire
properly will void the warranty and may result in damage to the machine. It is Gold Medal Products Co.’s
recommendation that this machine be plugged directly into a wall outlet. The use of extension cords is
not recommended due to safety concerns, and may cause sacrificed and/or reduced performance. Make
sure cord is located to prevent a trip hazard or unit upset.
BEFORE YOU PLUG IN MACHINE
1. Make sure all machine switches are in the OFF position before plugging the equipment into
the receptacle.
2. Make sure the wall outlet can accept the grounded plugs (where applicable) on the power
supply cord.
3. The wall outlet must have the proper polarity. If in doubt, have a competent electrician
inspect the outlet and correct if necessary.
4. DO NOT use a grounded to un-grounded receptacle adapter (where applicable).
5. Install the unit in a level position.
CAUTION
If the supply cord is damaged, it must be replaced by Gold Medal Products Co.,
its service agent or similarly qualified persons in order to avoid a hazard.
039_080614
