3
direction of IN on the handle to fix the latch in place.
4. Tighten the fixing screw properly.
5. Insert the search coil cable plug into the five pin jack on the front
control box’s housing.
6. Lengthen or shorten the stem, so when you stand upright with the
detector in your hand, the search coil is level with and about 1~5cm
above the ground. After that tighten the lock nut.
Caution:
The search coil cable plug fits into the connector only one way. Do not force the plug or
you could damage it.
You don’t need to disassemble the stem lock nut. In case you disassemble it carelessly,
place the washer on the top of the stem connected with the handle with the small head of
the washer upwards. Then hitch the stem lock nut on the washer then tighten it to lock it
in place.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the search coil’s end, then adjust the search coil to the desired angle.
(The search coil should be parallel with the ground.) Tighten the knobs just enough to keep the
search coil from rotating or wobbling.
INSTALLING BATTERY
You need two 9V alkaline batteries to power your detector.
Small head
assembly hole
fixing screw
latch
control box
