EN - 18
CHARGER AND BATTERY
•
Before charging, make sure the headset has been switched off.
•
Plug USB cable into the charging port of headset; plug the other
side of USB cable into the USB charger or other charging device.
Charging will start and the red light remains bright on the headset.
•
Charging time of headset takes approximately up to 1,5-2 hours, the
red light will switch off when fully charged.
Warning
: You must use the original cable to charge the Bluetooth
headset, otherwise it may damage the headset. Thus, voltage of
charger must be 5V, electric current exceed 100 mA (5 V/100 mA).
This headset uses a non-detachable built-in rechargeable battery,
in order to prevent damage to the headset, please do not remove
the battery.
Power on:
Keep pressing the MF button until blue light blinks.
Pairing Mode
: Keep pressing the MF button until blue and red lights
blink alternatively
Switch off
: Keep pressing the MF button until red light blinks and
goes out.
Pair your headset with your cell phone
: Keep the distance between
the headset and cell phone (or other devices being connected) within 1
meter. The closer the better. Keep pressing the MF button until the blue
and red lights blink alternatively. Initiate Bluetooth function of cell phone
(or other device being connected). Then “ GOGEN EBTM82STRB” will
be shown on your phone. Select “ GOGEN EBTM82STRB” (some cell
phones need you to input the PIN “0000” as password) and the headset
will automatically connect with your cell phone, the blue light begins to
blink. Attention: Generally, there is 120 seconds maximum to pair the
headset with your cell phone, or the Bluetooth pairing mode will stop
when the lights goes out. Please retry steps 1 to 4 to pair again if your
operation doesn’t work.
To disconnect the headset with your cell phone
: Turn off the
Bluetooth function of your cell phone, or keep pressing the MF button
until the red light goes out, to switch off the headset, or take the headset
from the cell phone to more than 20m away.
