GOG G-1, Operation And Adjustment Instructions, Page: 2 / 29

GOGpaintball.com
QUICK START
01 02
03
Unpack the G-1
TM
and its stock. Using the included 1/8-inch allen
wrench, attach the stock to the rear of the G-1 with the two included
screws.
Install the included barrel
into the G-1
TM
, screwing it
into place hand tight. Put the
supplied barrel blocker over
the end of the barrel, securing
its cord as far back on the
G-1
TM
body as possible, and
cinching it tight.
Fill the loader with paintballs. If it is a powered loader, turn it on. While wearing ASTM compliant paintball goggles, in an area where all bystanders are protected, remove the barrel
blocker and fire over a chronograph to measure the velocity. Using a 5/32-inch allen wrench on the adjuster in the bottom of the vertical regulator, turn clockwise to increase the
velocity/pressure, and counter-clockwise to decrease. Take three or four shots after every adjustment to allow the gas pressure inside the G-1
TM
to stabilize. Adjust until the marker
is firing consistently within the limits for the field where you are playing (for safety reasons, never adjust the G-1
TM
to fire at greater than 300 feet per second). Depending on what
modes of fire are allowed at the field where you are playing (semi-automatic, rebound, etc.) you may need to adjust the G-1
TM
’s firing mode. See the Electronic Adjustment section
for more information.
Fit a paintball loader into the feedbeck
of the G-1
TM
. Use a 7/64-inch allen
wrench to lock the loader in place.
Powered force-feed loaders are
recommended, as the G-1 has little
recoil, and can easily outpace an
unpowered or agitating loader.
Gently gas up the G-1
TM
by
slowly turning on the air system
or screwing the CO
2
or screw-
in style HPA system into the
bottom-line ASA.
A gentle rise in pressure is
important, as a sudden blast
may reduce the service life of
the G-1
®
’s internal components.
Turn on the G-1
TM
by
pressing the power button
momentarily.
Although the power button
serves as the G-1
TM
’s safety
switch to prevent accidental
firing, it should never be relied
upon in place of a barrel blocker
and proper eye protection.
04 05 06
STOCK BARREL BLOCKER FILL TANK
LOADER TURN ON GAS TURN ON THE G-1
TM
ADJUST VELOCITY
Have your compressed air
(HPA) or CO
2
tank filled by
a person who is properly
trained to do so. If using an
HPA system with an on/off
valve, make sure it is in the
OFF position. If using a CO
2
tank or screw-in style preset
HPA system, fill it while it is
removed from the marker.
07
00