ASSEMBLY INSTRUCTIONS
ELEVATED CHIN UP STATION
Place Self-Seating Bolts through holes
on
Leverage Bar
as shown —one Bolt
for each Side Bar. Side Bars will rest in
indentions on
Leverage Bar
.
Put Bolt through hole on
Side Bar
(adjust
height by choosing one of 3 holes).
Place Lock Washer on Bolt; thread on
Lock Nut. Repeat for each Side Bar.
Finger-tighten to secure Lock Nuts.
(Note: do not fully tighen with wrench
until Step 10).
Photo shows Leverage
Bar attached at center holes.
Step 1
Step 2
Step 3
Fully assembled— shown in chin up position
Fully assembled—shown in push up position
2
Shown in Push Up position
Step 6
Position
Curved Bar
as shown in fully
assembled photo above
(be sure curve
is facing correctly)
. Line up holes in
Curved Bar
with holes in
Side Bars
;
slide
Eye Bolts
through holes as shown.
Step 5
Slide two halves of
Curved Bar
together
(small end into larger end).
Line up holes
and put Short Hex Bolt through hole on
Curved Bar. Place Lock Washer on Bolt;
thread on Lock Nut. Finger-tighten.
Step 4
Slide two halves of
Straight Bar
together
(small end into larger end).
Line up holes
and put Short Hex Bolt through hole on
Straight Bar
. Place Lock Washer on Bolt;
thread on Lock Nut. Finger-tighten.
DO NOT tighten Bolts fully until you reach Step 10 to allow for assembly and leveling.
For questions or missing parts, please contact GoFit at 888-530-4441
©2017 GOFIT, L.L.C. TULSA, OK
