Digital Video Recorder: User manual
24
Picture 4.1 recording setup
[
Channel
] Choose the corresponding channel number to set the channel. Choose the 'All' option to set the entire channels.
[
Redundancy
] Choose the redundancy function option to implement the file double backup function. Double backup is writing the video file s in
two hard disks. When you do the double backup, make sure there are two hard disks installed. One is read-write disk and the other is redundant
disk. (refer to 4.5.1)
[
Length
] Set the time length of each video file. (60 minutes default value)
[
Pre-Record
] Record maximum 30 seconds before the action. (time length is decided by the code stream)
[
Mode
] Set video state: schedule, manual or stop.
Schedule
: Record according to the set video type (regular, detection and alarm) and time section.
Manual
: Click the button and the corresponding channel starts recording, no matter the channel in any state.
Stop:
Click the stop button and the corresponding channel stops recording, no matter the channel in any state.
[
Time section
] Set the time section of common recording. The recording will start only in the set range.
[
Recording type]
Set recording type: regular, detection or alarm.
Regular:
Perform the regular recording in the set time section. The video file type is “R”.
Detection:
Trigger the “motion detect”, “camera mask” or “video loss” signal. When above alarm is set as opening recording, the
“detection recording” state is on. The video file type is “M”.
