Digital Video Recorder: User Manual
16
2)
Preset point calls
In picture 3.10, click 'Page switch' button, enter PTZ control interface as shown in picture 3.12. In the input blank, write the preset point number,
then click 'Preset' button, PTZ turns to the corresponding preset point.
Picture 3.10 Preset Settings Picture 3.11 PTZ Control Picture 3.12 Tour between point settings Picture 3.13 Scan Setup
2. Tour between Points
Multiple preset points connected tour line, call tour points, the PTZ run around on the line.
1)
Tour between points settings
Tour line is connected by multiple preset points, setting procedure is as follows:
Step 1:
In picture 3.10, the Direction key will turn PTZ to designated location, click 'Set' button to enter Picture 3.13.
Step 2:
Click 'Tour' button, then write proper values in the 'Preset' box, then click 'Add preset' button and complete settings (al so can add or delete
tour which has been set up).
Step 3:
Repeat step 1 and step 2, until all the points in the preset designated tour is set.
Del Preset:
Please input preset value in the box, click 'Del Preset' button to remove the preset points.
Del Tour:
Input the number of tour line, click 'Del Tour' button to remove the tour lines set.
2)
The Calls of Tour between Points.
In picture 3.10, click 'Page Switch' button, enter PTZ control menu as shown in picture 3.12. Please input the number of tour in the box, then click
'Tour' & PTZ begins to work on the tour line.
3. Pattern
PTZ also can work on the preset scan line repeatedly.
