2.5. Electrical connection
2.6. Fitting the machine undercounter
WARNING:
Your machine is set to
operate at 220-240 V.
If you wish to fit your machine undercounter,
there must be sufficient space to do so and
the wiring-plumbing must be suitable to do
so (1). If the space under the countertop is
suitable for fitting your machine, remove the
worktop as shown in the illustration (2).
A:
If there is no felt on the top of the
product; you should take into account
this product's height.
B1:
If there is felt on the top of the product
with 2nd basket; you should take into
account this product's height.
B2:
If there is felt on the top of the product
with 3rd basket; you should take into
account this product's height.
The indoor fuse current value should
be 10-16 A.
WARNING:
The countertop, of which
the machine will be placed under, must be
stable in order to prevent imbalance. The top
panel of the dishwasher must be removed to
fit the machine under the countertop.
To remove the top panel, remove the screws
that hold it on, located at the rear of the
machine. Then, push the panel 1 cm from the
front towards the rear and lift it. Adjust the
machine feet according to the slope of the
floor (3).
Fit your machine by pushing it under the
counter taking care not to crush or bend the
hoses (4).
WARNING:
After removing the top
panel of your dishwasher, the machine
should be placed in a space of the
dimensions shown in the figure below.
The earthed plug of the machine
must be connected to an earthed outlet
supplied by suitable voltage and current.
In the absence of earthing
installation, an authorised electrician
should carry out an earthing installation.
In the case of use without earthing
installed, we will not be responsible for
any loss of use that may occur.
H1: min A
H2: min B1
H3: min B2
A
B
All
Products
B
1
(±2 mm)
820 mm
835 mm
830 mm
Products Height
B
2
7
