Goddess DFE1267DW9E, Instruction Manual

Page: 109 / 152

EN
EN - 109
6. TURNING ON THE APPLIANCE
Wash cycle table
Note: (*) Means: need to fill rinse into the Rinse-Aid Dispenser
Program
Cycle Selection
Information
Descripton
of Cycle
Detergent
pre/main
Runing
time (min)
Energie
(kWh)
Water (l)
Intensive
For the heaviest soiled loads,
such as pots, pans, casserole
dishes and dishes that have
been sitting with dried food on
them for a while.
• Pre-wash
• Main wash (60 °C)
• Rinse1
• Rinse2
• Hot rinse
• Drying
4/16 g
(or 3 in 1)
180 1,3 16,0
Eco
(*EN60436)
For normally soiled loads, such
as pots, plates, glasses and
lightly soiled pans.
Standard daily cycle.
• Pre-wash
• Main wash (44 °C)
• Hot rinse
• Drying
4/16 g
(or 3 in 1)
237 0,922 11
Light
For lightly soiled loads, such
as plates, glasses, bowls and
lightly soiled pans.
• Pre-wash
• Main wash (45 °C)
•
• Hot rinse
• Drying
3/15 g
(or 3 in 1)
137 0,85 14
60 min
For lightly and normally soiled
plates and pans for every day.
• Hot rinse
• Hot rinse
• Hot rinse (60 °C)
• Drying
3/15 g 60 0,95 10
Rapid
A shorter wash for lightly soiled
loads that do not need drying.
• Main wash (40 °C)
• Hot rinse
15 g 39 0,5 7
Pre-wash
To rinse dishes that you plan to
wash later that day
• Pre-wash - 11 0,01 4
Note: ECO (*EN60436) – This programme is the test cycle. The information for comparability test in accordance with EN60436.
Starting a cycle wash
1. Draw out the basket, load the dishes and push them
back.
2. Pour in the detergent (see the section e`ntitled Salt,
Detergent and Rinse Aid).
3. Insert the plug into the socket. The power supply is
220 – 240 V AC / 50 Hz, the specification of the socket
is 16 A 250 V AC. Make sure that the water supply is
turned on to full pressure.
4. Close the door, press the
ON/OFF
button, and the
ON/OFF light will turn on.
5. Press the program button. If a program is selected,
the response light will light. Then press the START/
PAUSE button, the dishwasher begins to wash.
WARNING!
When you press the START/PAUSE button to pause
during washing, the program light will stop blinking
and the dishwasher will mooing every minute unless
you press the START/PAUSE button to start.
Change the Programme
à
Premise: A cycle that is underway can only be
modified if it has only been running for a short time.
Otherwise, the detergent may have already been
released, and the appliance may have already
drained the wash water. If this is the case, the
detergent dispenser must be refilled (see the section
entitled “ Fill in the Detergent”).
à
Press “ Start/Pause ” button for 3s to cancel the
programme, then you can change the programme
to the desired cycle setting (see the section entitled
“Starting a wash cycle“).
NOTE
: If you open the door when washing, the machine
pauses and warning alarm rings. The display shows
the error message “E1”. When you close the door, the
machine will keep on working after 10 seconds.
The program lights show the state of the
dishwasher
à
One of the programme lights on → cycle running
à
One of the programme lights blinking → pause
WARNING!
It is dangerous to open the door when washing,
because the hot water may scald you.