EN
EN - 103
Detergents
There are 3 sorts of detergents
1.
With phosphate and with chlorine
2.
With phosphate and without chlorine
3.
Without phosphate and without chloride
à
Normally new pulverised detergent is without phosphate. The water softener function of
phosphate is not given. In this case we recommend to fill salt in the salt con tainer even
when the hardness of water is only 6 dH. If detergents without phosphate were used in
case of hard water often white spots appear at dishes and glasses. In this case please
ad d more detergent to reach better results. Detergent s wit hout chlorine do only bleach
a little. Strong and coloured spots will not removed completely. In this case please
choose a programme with higher temperature.
WARNING:
If the washing powder is not added, the washing effect will be
poor, resulting in increased water and electricity consumption for secondary washing
Use of „3 in 1“ Detergent Tablets
General Advice
à
Before using these products you should first check that the water hard-ness in your
supply is compatible with the use of these products as per the detergent manufacturers
instructions (on the product packaging).
à
These products should be strictly used according to the detergent manufacturers instructions.
à
If you encounter problems when using „3 in 1“ products for the first time then please
contact the detergent manufacturers care line (the telephone number is given on the
product packaging). These products are detergents with integrated and combined
detergent/rinse aid and salt functions.
à
Before using these products you should first check that the water hardness in your
supply is compatible with the use of these products as per the detergent manufacturers
(on the product packaging).
Special Advice
à
When using combination products, the rinse-aid and salt lights are no longer useful. It
may be helpful to select the lowest possible setting for water hardness.
To select „3in1“ function:
à
Press the power switch and select the 3in1 washing cycle by pressing the function
alternative button until the „3in1“ indicator blinks.
à
The 3in1 washing cycle will be available after pressing the start/pause button , and
the“3in1“ indicator lights.
To cancel „3in1“ function:
à
Follow the ‚Cancelling a programme in progress‘ instructions.If you decide to switch to
the use of a standard detergent system we advise that you:
à
Refill both the salt and rinse aid compartments.
à
Switch the water hardness setting to the highest possible position and run for three Eco
cycles without load.
à
Readjust the water hardness setting again according to the conditions for your region
(For more information please refer to your instruction manual). Note:3in1washing cycle is
additional function, they must be used with other programme (Intensive, Eco and Light).
Summary of Contents for DFE1267DW9E
Page 152: ...04 05 2021 MDA GOD02 2021...
