Goboservice GOLED, Instruction Manual, Page: 10 / 17

GOLED
- 10 -
WWW.GOBOSERVICE.COM
4. USE OF THE PROJECTOR
4.1. CONNECTION OF THE PROJECTOR TO THE MAINS SUPPLY
When connecting to the mains supply, standard safety and operating procedures applicable to any low
voltage device must be followed.
WARNING: it is essential that supply voltage and frequency are 230V-50/60Hz and that the power
supply circuit has a proper earth system together with a residual-current circuit breaker with the
following features:
-
Rated current I
n
= 20 A
-
Residual current I
Δn
= 0,03A
The projector is equipped with a power factor correction.
WARNING: Avoid any contact with water or liquids when the projector is connected to the main supply.
4.2. ORIENTATION AND FIXING OF THE PROJECTOR
The projector can be moved both upward than
downward; to orientate the projector loosen, on
both sides, the two special bolts (see Fig.8), place
the projector in the desired position and fasten
the bolts.
Furthermore, it is possible to adjust the direction
thanks to the two bolts situated on the projector
base (Fig. 9); unscrew just enough the two bolts,
then it will be possibile to rotate the projector
through 180 degrees; place the projector in the
desired position and fasten the bolts.
WARNING: Always refer to the informations
about the minimum distance of illuminated
objects (50cm).
Fig.8
Fig. 9