8
3
5
5
5
3
4
11
2
8
3
5
10
5
5
4
3
11
2
Figure 5
Figure 6
5.
NOTE: DO NOT tighten bolt
(#8) and nut (#4) completely
at this time.
Attach lower arm (#11) to Pole (#2), as
shown in
Figure 5
, using a bolt (#8),
two flat washers (#3), four plastic
washers (#5) and hex nut (#4).
NOTE: It is important for the installer to understand the necessity of the Plastic
Washers (#5) provided. These washers adequately space painted parts at all
pivot points. Neglecting the use of these washers will result in rusted parts.
NOTE: All board arms are made of rectangular tubing. Tightening hardware
too tight may damage tubing and make adjustment of system difficult.
NOTE: Make sure “Goalrilla” lettering is right side up.
6.
7.
Secure Actuator (#16) to Lower Arm (#11) using
one bolt (#8), two flat washers (#3), four plastic
washers (#5) and one hex nut (#4). See
Figure 6
.
Tighten both bolts (#8) securing Lower Arm (#11).
If the two Tube Plugs (#10) are not
already installed insert them into open
ends of Lower Arm (#11). It may be
necessary to use a rubber mallet to tap
plug in.
NOTE: Tighten bolts snug but,
Arms must pivot freely.
DO NOT over tighten. Board
16
7
Summary of Contents for B3200W
Page 2: ...2...
