Go Power GP-SW Owner'S Manual Download Page 3

Page: 3 / 3

GP-SW Remote

____________________________________________________________________________________________________

Step 3-

Continue using the remote only to turn the inverter ON and OFF.

5.0 Mounting the Remote

Step 1-

Cut out the template attached and position it on the wall where the remote is to be mounted.

Step 2-

Mark the location of the two holes, and the square area to be cut out. Note: Remote switch assembly requires 0.7” (18mm)

minimum clear panel depth.

Step 3-

Drill two holes, 7/64” (2.8mm) diameter and remove the cutout area.

Step 4-

Feed the connector and wire though the cutout hole in the panel and route the wire to the inverter receptacle (RS 232 Port).

Step 5-

Position the remote switch assembly upright and secure to the panel using the two screws provided. Plug the phone jack into the

inverter. Press the button to turn the inverter on and off.

6.0 Mounting Template

CARMANAH BATTERY

CAR BATTERIES

Summary of Contents for GP-SW

Page 1: ...GP SW Remote __________________________________________________________________________________ Owner s Manual...

Page 2: ...the remote button once when the LED is flashing yellow will turn on the inverter Holding the remote button for five seconds when the LED is a solid color will cause the LED to toggle between solid yel...

Page 3: ...and the square area to be cut out Note Remote switch assembly requires 0 7 18mm minimum clear panel depth Step 3 Drill two holes 7 64 2 8mm diameter and remove the cutout area Step 4 Feed the connecto...