AIR COMPRESSOR
CAUTION: DO NOT OVER INFLATE! Follow the manufacturer’s recommendations. This air compressor is designed for light duty. Please
allow the air compressor to cool if operating for more than 10 continuous minutes
1.
Make sure to read the item’s manufacturer inflation recommendations prior to inflating.
2.
Remove the air hose located in the compartment on the black of the unit, connect air hose to item to be inflated and use included
adapters if needed.
3.
Move the handle in the air hose down to lock adaptor in place.
4.
Turn on air compressor unit via the switch located on the side of the Power Station.
5.
Hold the air hose in place and once the desired air pressure is achieved turn off the air compressor unit via the switch located on
the side of the unit. Don’t use the air compressor for more than 10 minutes in order to avoid a danger.
6.
Disconnect the air hose from the item that has been inflated.
LIGHTS
The built-in lights are turned on by the switch on the front of the unit.
12 VOLT DC ADAPOR FUSE REPLACEMENTS
Should you overload the power station and cause the cigarette lighter plug fuse (2A) to open, unscrew the tip of the plug and replace as
shown in the diagram below. Determine the cause of the problem and remedy before attempting to use the unit again.
CAUTION: NEVER REPLACE A BAD FUSE WITH A FUSE THAT HAS A HIGHER AMPERAGE RATING THAN THE ORIGINAL 2A FUSE.
MAINTENANCE
RECHARGE ONCE EVERY 3 MONTHS TO KEEP UNIT IN TOP OPERATING CODITION.
ONCE THE BATTERY OF POWER STATION CAN’T RECHARGE, PLEASE STOP USING.
(Fig. 6)
2A
V211210
36
