Original instruction manual
En
43
04/2019
1. Place the radiator body upside-down on a scratch-free
location, make sure it is stable and will not fall.
2. Screw off the wing nuts from the U-shaped bolt provided,
attach the U-shaped bolt to the U-facing flange between
first and second fins (near the front cover).
3. To attach the castor mounting plate to the radiator body,
you should insert the threaded ends of the U bolt in the
holes on the castor mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing
nut properly.
Note:
do not over tighten, which may cause the damage of
radiator flange.
5. Screw off spherical nut from the castor, align the shaft to
the hole of the castor mounting plate, insert in, and screw
on the spherical nut.
6. Repeat 2, 3, 4 and 5 on the rear of radiator for mounting of
the rear castors.
Note:
The rear castors must be mounted between the end
two fins.
OPERATION
1. Before using the heater, make sure that it is on a flat and
stable surface. Damage may occur if it is placed on an
