GO Elliptical T-300MX, User Manual

Page: 40 / 43

- 40 -
The equipment can be maintained only if it is examined regularly for damage and wear, e.g. ropes , and /or pulleys,
connection points ETC.
Warning:
an advice to replace defective components imm. and/or keep the equipment out of use till repair also special attention to
components most susceptible to wear out.
2.
The total Mass and surface area please refer to the following drawing:
3.
For using each of the stationary training equipment must accompanied by the user's manual. also with following important
info:
Manufacturer Full address: LMX International Inc.,
11Floor No. 93 Nanking East Road Taipei Taiwan, www.go-elliptical.com
To use the machine must notice the min. area required with space not less than 0.6M greater than the training area in
the directions from which the equipment is accessed. the free area must also include the area emergency dismount. where
the equipment is positioned adjacent to each other the value of free area may be shared. The free area and training area
shall be illustrated with a dedicated figure.
Warning :
If any of the adjustment devices are left projecting , they could interfere with user's movement.
Warning:
The free standing equipment shall be installed on a stable and leveled base
Warning:
Maximum User body for this equipment is 300LB/ (136KGS)
T-700MX
Frame area: 168cm*77cm (1.29 square meter)
Weight of the unit is 90 KGS
T-300MX
Frame area: 160cm*77cm(1.23 square meter)
Weight of the unit is 87 KGS