GNE 157307, Installation, Operation And Maintenance Manual, Page: 14 / 28

14
Cleaning The Inlet Filter
WARNING: Check whether dangerous chemicals have
been used and take precautions when handling filters.
A.) Unscrew clear tube by hand.
B.) Remove Inlet filter
C.) Run water though to clean filter
Checking the Tire Air Pressure
A.) Remove air fill cap
B.) Fill tire to 20psi (1.4bar)
C.) Replace air fill cap
Checking the Hoses
WARNING: Do not use a finger or skin to check for
leaks. Escaping fluid under pressure has sufficient
force to penetrate the skin, causing serious injury. Do
not operate the pressure washer if the hose is cracked,
worn or leaking.
A.) Check all hoses for leaks
B.) Check all hoses of worn areas
Changing The Pump Oil
*Change oil after first 50 hours, then every 3 months or 500
hours
1.) Remove oil drain plug
2.) Drain pump oil.
3.) Replace oil drain plug.
4.) Fill pump oil according to table below.
5.) Use sight glass to fill to proper level.
Quantities Of Fluid
Pump Type of Fluid QTY
CAT SAE 30** 8.5 oz (0.25L)
*
*
Non-Detergent Oil (order pump oil Item #22158)
Burner Fuel Filter
Drain water which has accumulated in the fuel filter
bowl and replace the filter as needed.
Filter
Water Drain
FIG02300
Air Fill Cap
Air Fill Stem
Good
Bad
Bad
Wire Mesh
Water
Filter
Water Drain
Oil Fill
Oil Drain Plug
(Underneath)
Cat
Pump