GNB SCR100-06-260S1Z, Installation & Operating Instructions Manual, Page: 6 / 38

Instr. 4770-65-95005-00 Page
2
SCR100 SERIES INDUSTRIAL BATTERY CHARGERS
1.0 IMPORTANT OPERATING AND SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
a) Before using the battery charger, read all the instructions in addition to the CAUTION, WARNING, and DANGER
markings on the charger, battery and all the associated equipment.
b) Do not touch uninsulated parts of the DC output connector or the battery terminals, as there is a possibility of
electric shock.
c) Connect or disconnect the battery plug only when the charger output is off; ALWAYS press the STOP
pushbutton before unplugging the battery to prevent arcing or burning.
d) If the battery is unplugged during charging, the charger will indicate “OFF/FCA”. To restart the charger, plug in the
next battery. Do not connect the next battery before you see indication “OFF/FCA”.
e) Only qualified personnel should operate or service this equipment.
f) De-energize all AC and DC power connections before servicing this unit. If injury does occur, apply the prescribed
treatment for electrical shock and obtain medical attention immediately.
g) The charger is NOT for outdoor use. Do not expose the charger to rain or snow.
h) This charger is factory set to charge lead-acid batteries only. Operating environment should not contain any
contaminations that may cause corrosion or contamination that would degrade the performance of a charger.
i) Do not operate this unit if it has received a sharp blow, been dropped or otherwise damaged. Take it to a qualified
GNB service center.
j) Do not disassemble the charger. Have the charger examined by a GNB service representative or local qualified
service facility. Incorrect re-assembly of the charger may result in an explosion, electric shock or fire.
k) The charger profile is set at the factory for a charger DC cable length of 9ft and a battery DC cable length of 25in.
If DC cable lengths are adjusted please contact you local GNB service representative.