English
21
MAINTENANCE
Recommendations for the dental equipment maintenance.
Your Gnatus equipment has been designed and developed according to the standards of modern
techology. Similarly to other kinds of equipment, it requires special care, which is many times neglected
due to several reasons and circunstances.
Therefore, here are some important reminders for your daily routine. Try to follow these simple rules,
which will save you a lot of time and will avoid unnecessary expenses once they start making part of your
working procedure.
Precautions
- Install your equipment in an appropriate place away from sunlight exposure and humidity.
- The equipment and the light conductor cannot be placed in the oven or autoclaves.
- The conductor can’t be immersed in solvents or substances that contain acetone in its composition.
- Avoid the light conductor to terminal to touch the resin to be polymerized.
- When using the Optilight LD Max check if the light conductor output doesn’t have residues that
might obstruct the light beam.
INTERCHANGEABLE AND/OR REMOVABLE PARTS REPLACEMENT
If stains, fissures or scratchs where detected in the eyesight protection or in the light conductor,
replace damaged components.
Cleaning conductor
The light conductor cleaning and the optical protector must be done using only neutral soap and
cotton. To the exterior of the pen
use neutral soap or alcohol 70% vol.
Never use any other chemical based product than previous mentioned, because along the time
these products attack the surface of the instrument.
Never immerse the instrument in disinfection baths.
Cleaning the equipment
To clean the equipment, we recommend the use of “BactSpray
(Reg nº MS:
3.2079.0041.001-5)
or any other similar product:
Active component:
Benzalkonium chloride (tri-quaternary ammonium)
Solution 50%................................................. 0.329%
Chemical composition:
Butyl Glycol, Decyl polyglucose, Sodium Benzoate, Sodium
Nitrate, Essence, Deodorized Propane / Butane, demineralized Water.
For more information concerning cleaning procedures, see manufacturer’s
instructions.
WARNING:
• In order to prevent risks and damages to equipment, make sure that the liquid does
not enter into the unit.
• The application of other solvent-based cleaning products or sodium hypochloride
isn’t recommended, because they may damage the equipment.
Summary of Contents for Optilight LD Max
Page 1: ......
Page 8: ...English 19 Dimensions mm TECHNICAL SPECIFICATIONS ...
