GMX MOTORBIKES HAMMER DUNE, User Manual

Page: 16 / 43

PRE-RIDE INSPECTION
12.
To Adjust Seat:-
1. Make sure the engine is stopped
2. Move the lever under the seat pad to the left and slide the seat into
correct position
Passenger Restrain System
This product is fitted with a operator restraint system. It is to be used at all
times to keep you safely in the product.
WARNING – Failure to adjust and wear the restraint system properly may
result in the operator moving around whilst riding and can result in personal
injury or death
WARNING –
Always keep all parts of your body within the seat and frame
CAUTION – When safety belt is not in use it must be securely fastened so it
STARTING
1. Apply the park brake
2. Make sure the throttle is in idle position
3. Make sure the fuel tap in in the on position
4. Turn the engine stop switch to “RUN”
5. Depress the brake pedal
6. Insert the key and turn to the start position to start the engine
7. When the engine starts, test the engine stop switch.
NOTE:
If the engine fails to start proptly there may be an issue or an indica-
tion of a malfunction or errors in the starting procedure. DO NOT continue to
start the engine> pause a few seconds and then try again. If the engine fails
to start, contact dealer for assistance.
RUNNING
Operate the product in a large, level, open space in order to learn to start,
steer and stop properly. Operate the product at low speed until you are
comfortable and confident in operating it. Avoid sharp turns, high speed and
rough ground at all times.
• Always stay at low speeds when turning
• Always keep all four tyres on the ground
• Remember “the sharper the turn, the lower the speed”
• Do not race, jump or perform stunts
STOPPING
Release the throttle to return the engine speed to idle. Apply the brake pedal
to stop the motion.
• Operator must not be too small or too large for the product
• Operator must be of sufficient age, understanding, mental capacity
and physical capability to safely operate the product
• Safe operation includes the responsibilty to be aware of any other
people near the product
• The product should only be operated after mature, supervised
instructions and sufficient practice has taken place. In an area without
OPERATING THE PRODUCT