GMR STENSBALLE, User Manual

Page: 25 / 34

GMR maskiner a/s Page 25
STENSBALLE rotary mowers
Operating Instructions
GB
Maintenance and storage
After cleaning
Lubrication
Daily
After 50 operating hours
Angular gear
1. Start the tractor and raise the hitch into the top position.
2. Tilt the mower down to horizontal, and continue to activate the
hydraulic valve until the cylinder is completely in the outer position.
3. Lower the mower to the ground.
4. Stop the tractor and remove the key before you leave the tractor
cab.
5. Turn the lever on the switch valve back to the working position.
6. Attach the PTO shaft. (Applies only to mechanical machines)
The machine has labels attached for grease and oil lubrication,
respectively.
• Wheel bushings grease
• Wheel hub grease
• Bearing housing
for rotary shafts grease
• Cylinder eyes grease
• Adjustable tilting arm oil
• Fixed tilting arm grease
The angular gear is half filled with oil at the factory. According to the
gear manufacturer, the first oil change should be performed after 50
working hours and subsequently at intervals of 500-800 hours, but at
least once per year.
To prevent sedimentation, we recommend that you change the oil while
it is warm. Use an SAE 90 EP oil. If necessary, use an oil syphon to
remove the used oil.