ERROR MESSAGE
☞ "H-Err"
If laminating roller temp. is fluctuated by 25℃ in 0.5 sec., the message is displayed.
This is caused by trouble in temp. sensor.
Contact to a supplier.
☞ "L-TEMP"
This message appears if a certain amount of actual temperature of the roller is lower than
setting temperature when laminating or when you increase the laminating speed.
This message disappears when the temperature of the roller is compensated.
Please continue your work when this message disappears.
☞ "STAND BY STATUS!!" & POWER OFF!!"
This function is to shut off the power of the heater when it is not used
for a certain period for safety purpose and to save electricity
The machine enters to Stanby mode when 2-hour-time is passed when the machien is in stop mode
In STAND BY STATUS, the temperature of the roller will not exceed 80℃. After an hour after STAND BY STATUS,
the machine enters to POWER OFF mode which makes the Heat roller temperature to 0℃.
These modes can be disabled by pressing RUN BUTTON, all settings will be back to before STANDBY Status.
POWER SAVE Status Message
M:Poly-L SPD:03
T:H-Err B:1000
B:100
℃
W C:00010
L:0315 MAN
M:Poly-L SPD:03
T:100
℃
R B:1000
B:100
℃
W C:00010
STAND BY STATUS!!
M:Poly-L SPD:03
T:100
℃
R B:1000
B:100
℃
W C:00010
POWER OFF!!
M:Poly-L SPD:03
T:100
℃
R B:1000
B:100
℃
W C:00010
L:0315 L-TEMP
20/51
