GMC REDEYE DB305SMS, Manual

Page: 14 / 104

14
GB
14. Retighten the Bevel Lock (16) and the lock nut securing the 0° Bevel
Adjustment Screw (35)
Note: The above procedure can also be used to check the angle of the
saw blade to the table at either 45° bevel angle to the left or to the right.
The 45° Bevel Adjustment Screws (33 & 34) are on opposite sides of
the saw arm. You will need a 13mm spanner or adjustable spanner (not
supplied) for the lock nut (Fig. X) and the 6mm hex key for the set screws
(Fig. Y).
Setting the fence square with the table
1. Make sure that the electrical plug is removed from the power point
2. Push the Saw Arm (5) down to its lowest position and engage the
Release Knob (6) to hold the saw arm in the transport position
3. Loosen the Mitre Lock (25)
4. Rotate the Table (21) until the
pointer is positioned at 0°
5. Tighten the Mitre Lock (25)
6. Using the 6mm hex key provided,
loosen the hex screw securing the
top piece of the right hand side
fence (Fig. Z) and remove this top
section
7. Again using the 6mm hex key,
loosen the four screws securing
the Fence (19) to the base (Fig. a)
8. Place a square against the Fence (19) and alongside the Blade (Fig. b)
9. Adjust the Fence (19) until it is
square with the blade
10. Tighten the screws securing the
Fence (19)
11. Loosen the Phillips head screw
holding the pointer of the Mitre
Scale (22) and adjust it so that
it accurately indicates the zero
position on the Mitre Scale (Fig. c)
12. Retighten the screw securing the
mitre scale pointer
13. Replace the top section of the
fence and secure the hex screw using the 6mm hex key
Operation
IMPORTANT: When using this tool, always wear all the safety equipment
required. See ‘Safety’ for details.
Turning on and off
• To turn the saw on, depress and
hold the On/Off Trigger Switch (24)
(Fig. d)
• To turn the saw off, release the on/
off trigger switch
Using the laser guide
system
The laser line generator emits 2
intense narrow beams of pure red light
to guide you as you cut.
It improves operator cutting vision, enables faster set-up, increases
accuracy and improves safety.
WARNING
• Do not stare directly at the laser beam
• Never aim the beam at any person or an object other than the
workpiece
• Do not aim the beam at reflective surfaces as the reflective surface
could direct the beam back at the operator
• Always remember to switch off the Laser On/Off Switch (2) after
finishing a job. Only turn the laser beam on when the workpiece is on
the mitre saw table
1. Mark the line of the cut on the workpiece
2. Adjust the angle of mitre and bevel of the cut as required
X
Y
Z
a
b
90°
c
d
PDF Compressor Pro