GMC REDEYE CDB250MS, Instruction Manual

Page: 4 / 20

4
Specifications
CDB250MS CDB305MS
Input power: 2000W 2400W
No load speed: 5000 RPM 5000 RPM
Blade size: Ø250mm x Ø305mm x
Ø16mm bore Ø16mm bore
Number of teeth: 24 30
Mitre table angles: 0° to 52° 0° to 52°
left & right left & right
Bevel cuts: 0° to 45° 0° to 45°
left & right left & right
Straight cut
0° x 0°: 160mm x 65mm 200mm x 80mm
Mitre cut
45° (R) x 0°: 110mm x 65mm 140mm x 80mm
52° (R) x 0°: 95mm x 65mm 122mm x 80mm
45° (L) x 0°: 110mm x 65mm 140mm x 80mm
52° (L) x 0°: 95mm x 65mm 122mm x 80mm
Bevel cut
0° x 45° (R): 160mm x 17mm 200mm x 22mm
0° x 45° (L): 160mm x 39mm 200mm x 43mm
Compound mitre cut
45° (R) x 45° (R): 110mm x 17mm 140mm x 22mm
52° (R) x 45° (R): 95mm x 17mm 122mm x 22mm
45° (L) x 45° (L): 110mm x 39mm 140mm x 43mm
52° (L) x 45° (L): 95mm x 39mm 122mm x 43mm
Safety rules for laser lights
The laser light/laser radiation used in the GMC REDEYE
®
system is Class 2 with maximum 1mW and 400nm – 700nm
wavelengths. These lasers do not normally present an
optical hazard, although staring at the beam may cause
flash blindness.
WARNING. Do not stare directly at the laser beam.
A hazard may exist if you deliberately stare into the beam,
please observe all safety rules as follows;
• The laser shall be used and maintained in accordance
with the manufacturer’s instructions.
• Never aim the beam at any person or an object other
than the workpiece.
• The laser beam shall not be deliberately aimed at
personnel and shall be prevented from being directed
towards the eye of a person for longer than 0.25s.
• Always ensure the laser beam is aimed at a sturdy
workpiece without reflective surfaces. i.e. wood or rough
coated surfaces are acceptable. Bright shiny reflective
sheet steel or the like is not suitable for laser use as
the reflective surface could direct the beam back at the
operator.
• Do not change the laser light assembly with a different
type. Repairs must be carried out by the laser
manufacturer or an authorised agent.
����������������������������
�����������������������
����������������������������������
���������������������������������������
CAUTION. Use of controls or adjustments or performance
of procedures other than those specified herein may result
in hazardous radiation exposure.
Please refer to the relevant Australian standards, AS 2397
and AS/NZS2211 for more information on Lasers.