![background image](http://html1.mh-extra.com/html/gmc/rdc100/rdc100_instruction-manual_2235692004.webp)
2. Consider the environment in which you are working.
Do not use power tools in damp or wet locations. Keep
the work area well lit. Do not expose power tools to
rain. Do not use power tools in the presence of
flammable liquids or gases.
3. Keep visitors away from the work area.
All visitors
and onlookers, especially children and infirm persons,
should be kept well away from where you are working.
Do not let others in the vicinity make contact with the
tool or extension cord.
4. Store tools safely.
When not in use, tools should be
stored in a dry, high place or locked up out of the
reach of children.
5. Do not force the tool.
The tool will do the job better
and safer working at the rate for which it was
designed.
6. Use the correct tool for the job.
Do not force small
tools or attachments to do the job best handled by a
heavier duty tool. Never use a tool for a purpose for
which it was not intended. For instance, do not use
circular saws to cut tree limbs or logs.
7. Dress correctly.
Do not wear loose clothing or jewelry.
They can be caught in moving parts. Rubber gloves and
non-slip footwear are recommended when working
outdoors. If you have long hair, wear a protective hair
covering.
8. Use safety accessories.
Safety glasses and earmuffs
should always be worn. A face or dust mask is also
required if the cutting operation creates dust.
9. Do not abuse the power cord.
Never pull the cord to
disconnect the tool from the power point. Keep the
cord away from heat, oil and sharp edges.
10. Secure the work piece.
Use clamps or a vice to hold
the work piece. It is safer than using your hand and
frees both hands to operate the tool.
11. Do not overreach.
Keep your footing secure and
balanced at all times.
12. Look after your tools.
Keep tools sharp and clean for
better and safer performance. Follow the instructions
regarding lubrication and accessory changes. Inspect
tool cords periodically and, if damaged, have them
repaired by an authorised service facility. Inspect
extension cords periodically and replace them if
damaged. Keep tool handles dry, clean and free from
oil and grease.
13. Disconnect idle tools.
Switch off the power and
disconnect the plug from the power point before
servicing, when changing accessories such as blades,
bits and cutters, and when the tool is not in use.
14. Remove adjusting keys and wrenches.
Check to see
that keys and adjusting wrenches are removed from
the tool before switching on.
15. Avoid unintentional starting.
Always check that the
switch is in the OFF position before plugging in the
tool to the power supply. Do not carry a plugged in
tool with your finger on the switch.
16. Use outdoor rated extension cords.
When a tool is
used outdoors, use only extension cords that are
intended for outdoor use and are so marked.
17. Stay alert.
Watch what you are doing. Use common
sense. Do not operate a power tool when you are
tired or under the influence of drugs or alcohol.
18. Check for damaged parts.
Before further use of the
tool, a guard or other part that is damaged should be
carefully checked to determine if it will operate
properly and perform its intended function. Check for
alignment of moving parts, free running of moving
parts, breakage of parts, proper mounting and any
other conditions that may affect the operation of the
tool. A guard or other part that is damaged should be
properly repaired or replaced by an authorisedservice
facility, unless otherwise indicated in this Instruction
Manual.
Defective switches must be replaced by an authorised
service facility. Do not use a tool if the switch does
not turn the tool on and off correctly.
19. Guard against electric shock.
Prevent body contact
4