GMC LTP25SS, Instruction Manual

Page: 8 / 16

8
Fitting the secondary handle
WARNING. Before each use, ensure the secondary handle
cannot swivel by tightening the secondary handle locking
knob. Over time, the knob may vibrate loose.
1. The line trimmer has been
pre-packed with the secondary
handle facing in the opposite
direction to where it must sit
during use.
2. Rotate the secondary handle
by 180°.
3. Slide the 6mm x 35mm
long hex head bolt through both
holes in the underside of the
handle. Ensure the hex head
of the bolt is fully located in the
hex recess in the side of the
handle.
4. Fit the small flat washer on
the end of the thread and then
secure the handle using the
yellow knob to tighten on the
previously fitted handle bolt.
The handle can be positioned
up and down the shaft to suit
the operators comfort.
Mixing the fuel
MOTOR FUEL: MIX AT 40:1 ONLY
IMPORTANT.
Use good quality air cooled 2-stroke
engine oil.
This product is powered by a 2-stroke engine and requires
pre-mixing fuel with 2-stroke oil.
1. Use fresh unleaded petrol.
You must use 2-stroke oil
specifically made for heavily
stressed two-stroke engines.
2. Mix the petrol and oil in an
approved container. Never
mix fuel directly in the line
trimmer fuel tank. Use the fuel
mixing bottle included with this
product.
Note. Mixing has been made easy by
including markings on the container
included. For example, if unleaded fuel
is filled to the ‘400’ mark in the “GAS”
column of the container, place oil in the container until it
reaches the next mark (in the 40:1 OIL markings of the
container). Therefore, 400ml of fuel would mean 10ml of oil
must be added.
WARNING. Never use any type of pre-mixed fuel/oil direct
from fuel stations. This may include special blends intended
for use in mopeds, motorcycles, etc.
3. Mix the fuel thoroughly and also each time before fuelling.
4. Always pre-mix in small quantities. Never mix quantities
larger than what will be used in a 30-day period.
Note. The mixing bottle provided is NOT for the storage of
fuel. This container is solely for mixing of fuel only.
Ensure to keep this container in a safe storage location,
empty of fuel and out of reach of Children.
rotate 180º
operational
position
pre-packed
position
40:1