10
table is at approximately 90º to the blade and securely
tighten the table lock knob (17).
3. Loosen the Phillips head screw holding the degree scale
pointer and move the pointer to the 0º position. Securely
tighten the screw.
Note.
The degree scale is a convenient guide but
should not be relied upon for precision. Always make
a practice cut in scrap wood to determine if your angle
settings are correct.
Turning on and off
1. To turn on the scroll saw lift the on/off switch (1).
2. To turn off the scroll saw push the on/off switch (1) down.
Sawdust blower
Your scroll saw features a
sawdust blower (6) to help keep
the work area clean for more
accurate scroll cuts. The blower
tube is factory set to direct air
flow at the blade and workpiece.
LED light
The LED light will illuminate the work area for greater
visibility of the cutting line.
1. To turn on the LED light press the LED light button (3)
on the control panel.
Note.
The LED light will not function if the saw is not in the
‘on’ position.
Adjusting the laser line
1. To adjust the laser beam first turn on the scroll saw using
the on/off switch (1)
2. To adjust the laser line turn the
laser line alignment knob (5) in
an anti-clockwise direction to
loosen it and then move it to
the left or right until the laser
line is in line with the blade.
Turn the laser line alignment
knob (5) in a clockwise
direction to tighten it.
3. Turn off the scroll saw.
90
O