![background image](http://html.mh-extra.com/html/gmc/dp250ls/dp250ls_instruction-manual_2235797005.webp)
5
7. Dress correctly.
Do not wear loose clothing or jewellery.
They can be caught in moving parts. Rubber gloves
and non-slip footwear are recommended when working
outdoors. If you have long hair, wear a protective hair
covering.
8. Use safety accessories.
Safety glasses and earmuffs
should always be worn. A face or dust mask is also
required if the sanding operation creates dust.
9. Do not abuse the power cord.
Never pull the cord to
disconnect the tool from the power point. Keep the cord
away from heat, oil and sharp edges.
10. Secure the work piece.
Use clamps or a vice to hold
the work piece. It is safer than using your hand and
frees both hands to operate the tool.
11. Do not overreach.
Keep your footing secure and
balanced at all times.
12. Look after your tools
. Keep tools sharp and clean for
better and safer performance. Follow the instructions
regarding lubrication and accessory changes. Inspect
tool cords periodically and, if damaged, have them
repaired by an authorised service facility. Inspect
extension cords periodically and replace them if
damaged. Keep tool handles dry, clean and free from oil
and grease.
13. Disconnect idle tools.
Switch off the power and
disconnect the plug from the power point before
servicing, when changing accessories and when the tool
is not in use.
14. Remove adjusting keys and wrenches.
Check to see
that keys and adjusting wrenches are removed from the
tool before switching on.
15. Avoid unintentional starting.
Always check that the
switch is in the OFF position before plugging in the tool
to the power supply. Do not carry a plugged in tool with
your finger on the switch.
16. Use outdoor rated extension cords.
When a tool
is used outdoors, use only extension cords that are
intended for outdoor use and are so marked.
17. Stay alert.
Watch what you are doing. Use common
sense. Do not operate a power tool when you are tired.
18. Check for damaged parts.
Before using a tool, check
that there are no damaged parts. If a part is slightly
damaged, carefully determine if it will operate properly
and perform its intended function. Check for alignment
of moving parts, binding of moving parts, breakage
of parts, proper mounting and any other conditions
that may affect the operation of the tool. A part that is
damaged should be properly repaired or replaced by an
authorised service facility, unless otherwise indicated in
this Instruction Manual.
Defective switches must be replaced by an authorised
service facility. Do not use a tool if the switch does not
turn the tool on and off correctly.
19. Guard against electric shock
. Prevent body contact
with grounded objects such as water pipes, radiators,
cookers and refrigerator enclosures.
20. Use only approved parts.
When servicing, use only
identical replacement parts. Use an authorised service
facility to fit replacement parts.
Additional safety rules for drill presses
WARNING.
For your own safety, do not try to use your
drill press or plug it in until it is completely assembled and
installed according to the instructions and until you have
read and understood the following:
1. Your drill press must be bolted securely to a workbench. In
addition, if there is any tendency for your drill press to move
during certain operations, bolt the workbench to the floor.
2. This drill press is intended for use in dry conditions and
indoor use only.
3. Always wear safety goggles which comply to a recognised
standard. Use a face or dust mask along with safety
goggles if the drilling operation is dusty. Use ear protectors,
especially during extended periods of operation.
4. Do not try to drill material too small to be securely held.
Do not drill material that does not have a flat surface
unless it is clamped securely.
Summary of Contents for DP250LS
Page 15: ...15 ...