GMC Corvette 1984 Repair Manual Download

Page: 1 / 4

GM Corvette 1984-1996 Repair Guide

Distributor

REMOVAL & INSTALLATION

See Figures 1, 2, 3, 4 and 5

For 1995-96 vehicles, inspect the distributor ventilation system for proper ventilation.

Be sure the ignition is in the

OFF

LOCK

position. Disconnect the negative battery cable.

Detach the Intake Air Temperature (IAT) electrical connector.

Remove the air intake duct.

Fig. Fig. 1: Unfasten the retainers, then remove the air intake duct

Remove the accessory drive belt, as outlined in General Information & Maintenance of this repair guide.

Drain the engine cooling system into a suitable container.

Disconnect the water pump coolant hoses, and allow any remaining coolant to drain.

Detach the Engine Coolant Temperature (ECT) sensor electrical connector.

1992 Chevrolet Corvette 5.7L SFI OHV 8cyl

1 of 4

8/11/2010 1:24 PM

Summary of Contents for Corvette 1984

Page 1: ...Temperature IAT electrical connector 3 Remove the air intake duct 4 Fig Fig 1 Unfasten the retainers then remove the air intake duct Remove the accessory drive belt as outlined in General Information...

Page 2: ...T sensor Remove the water pump and crankshaft balancer as outlined in Engine Engine Overhaul of this repair guide 9 Fig Fig 3 The water pump must be removed for access to the distributor 1992 Chevrole...

Page 3: ...p surface of the driveshaft for proper alignment during installation 16 To install Replace the O rings on the coupling shaft or ignition system performance may suffer Lubricate the O rings and the end...

Page 4: ...removal 21 Install the drive belt tensioner 22 Install the crankshaft balancer and water pump as outlined in Engine Engine Overhaul of this repair guide 23 Attach the ECT sensor connector 24 Refill th...