Reprogramming a Single HomeLink
®
Button
To program a device to HomeLink
®
using a HomeLink
®
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
®
button. Do
not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
®
button, proceed with Step 2 under “Programming
HomeLink
®
” shown earlier in this section.
Resetting Defaults
To reset HomeLink
®
to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
®
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
®
at
1-800-355-3515, or on the internet at
www.homelink.com.
Storage Areas
Glove Box
Open the glove box by pulling the bottom of the handle
upward.
Cupholder(s)
Your vehicle may have cupholders located in the front
console, or in the fold-down armrest.
Coinholder(s)
Your vehicle may have a coin holder inside the center
console storage area.
2-70
Summary of Contents for 2005 Sierra 1500 Pickup
