Running multiple vehicle
If you have a vehicle of your and your friends with other vehicles that you will be racing with, it is very important that you
fi rst check what frequency channel your vehicle is on and confi rm that none of your friends have the same frequency
as yours. If you do fi nd that someone else is using the same frequency channel that you are, you must wait for them to
turn their transmitter and vehicle OFF or you may choose to change the frequency crystals in your transmitter and recei-
ver (so that you can run together at the same time without causing any radio interference). Additional frequency crystal
sets can be purchased separately and installed in a few quick seconds. To change frequency crystals simply remove
the black plastic crystal holder from the back of your transmitter by carefully pulling it straight out. Slide the crystal out
of the holder and install the new crystal labelled „Tx“ in its place. Then carefully align the two pins that extend from the
transmitter, and gently press it into place. DO NOT force the crystal! The pins can easily be broken! Remove the crystal
from your receiver in the same careful manner using a pair of needle-nose pliers and install the new „Rx“ crystal in its
place.
PLEASE NOTE: It is very important that the crystal labelled „Tx“ is installed in the transmitter and the crystal marked
„Rx“ is installed in the receiver.
REMOTE CONTROL (TRANSMITTER)
1.
On / off switch:
Turns the power on/off
2. Steering
wheel:
Controls direction (left/right) of the model
3. Steering
trim
: Adjusts the “hands off” direction of the model
4. Throttle
Trigger:
Controls speed (forward/brake) of the model
5. Throttle
Trim:
Adjusts the motor speed to stop at neutral
6. Control
light:
indicates adequate battery power
7. Antenna:
Transmits signal to the model
The remote control system of the Flash 3.0 is optimally adjusted by the factory. Nevertheless you should read the follo-
wing chapter, maybe slight adjustments on the remote control should be necessary. For further information to the remote
control system please refer to the enclosed XG-6 manual.
OPERATING THE REMOTE CONTROL
•
Run your Flash 3.0 Nitro never with low transmitter or receiver batteries.
• Never forget switch off the radio after running your Flash 3.0 Nitro, otherwise the batteries do not last long.
• Turn on the transmitter fi rst, then the vehicle.
• After driving fi rst turn off the vehicle, then the transmitter.
• For optimal use fi rst check the steering and throttle trim positions:
Before the fi rst trip you should be sure all of these functions and settings have read and understood.
•
GM-Racing 90171.RTR Flash 3.0 Race Nitro 4WD Buggy 14
Summary of Contents for Flash 3.0 Nitro
Page 41: ...GM Racing 90171 RTR Flash 3 0 Race Nitro 4WD Buggy 62 ...
Page 46: ......
