How to measure the blood glucose/ketone value.
1. Wash your hands with soap and water.
2. Take a glucose or ketone test strip.
3. Put the gold-coloured contact area of the strip in the
test strip port of the meter.
4. The meter shows a blinking blood drop and is now
ready to perform a measurement.
5. Lance yourself with the lancing device.
6. Set the blood drop against the short end of the test
strip, which automatically will draw up the right
amount of blood.
7. When you have read your blood glucose value (after
4 seconds for glucose strips and 10 seconds for ketone
strips), take out the test strip and discard it. The meter
shuts off automatically.
This is how you use the value mark-up function
(only glucose values)
1. Select one of the mark-ups with the arrow buttons
(”before meal”, ”after meal”, ”training” or”check”).
2. Confirm the selection by pressing the -button.
3. When selecting the mark-up ”before meal” an alarm
can be activated to go off after 2,5 hours for a ”after
meal” test. Select activation with the arrow buttons
and confirm with the -button.
Note. The meter is noT automatically saving a mark-up if the strip is removed
or if one minutes passes.
3.
6.
Öppning för
teststickan
Kontaktyta
Quick guide
for GlucoMen LX PLus
Customer service 040-32 12 70 or [email protected]
Changing the battery.
GlucoMen® LX is powered by one CR2450 battery.
When battery strength is low, the meter shows in
the upper right-hand corner and a blood drop in the
lower left corner. You then have power for approximately
20 additional measurements. The battery symbol will
remain until you have changed the battery. Contact our
customer service at tel. 040-32 12 70, and we will send
you a new battery free of charge.
1. Open the battery slot on the back of the meter.
2. Pull out the old battery and .and put in a new
battery in, with the”+” symbol facing upward.
3. Put the cover back on.
engelska
