13
(instruction version 0.91)
GLP
z
German Light Production
3.9.7 Default Settings
(DFSE)
DFSE
Press
Enter
to reset all fixture personalities (not the adjusted functions) to
the default values. On the display will appear
ok
to indicate that the defaults
are set.
Function
Display
Default Values
DMX Address
D001
D001
Pan reverse
RPAN
ON
OFF
9
Tilt reverse
RTLT
ON
OFF
9
Automatic lamp on
LAAU
ON
OFF
9
Lamp on via DMX
DLOF
ON
9
OFF
Display
DISP
D ON
9
REV
Cooling fan
FANS
HIGH REG
9
LOOF LOHI
3.9.8 Correction of faults
(EFLG)
(Function available for authorized persons only)
3.10 Error and Information Messages
HEAt
This message appears if you try to switch on the lamp within 5 minutes
after having switched off (lamp too hot). The message will appear on
the display if the lamp doesn’t ignite within 20 seconds. The fixture will
store this command and automatically ignite the lamp after 5 minutes.
LaeR
After the ignition of the lamp was two times not successful the display
will show
LAER
. That means the lamp could be damaged or even
missed, the fixture is overheating or there could be a failure on the
igniter or ballast. Switch off the power supply and solve the possible
problem.
OTMP
This error message informs you that the fixture was overheating and
that the relay switches off the lamp. Pleas look for possible reasons (fan
faulty, air in/outlets blocked or very dirty, lamp broken or very old, too
high ambient temperature. Switch off the power supply and solve the
possible problem.
RsER
This message informs you that one of the fixture function wasn’t able to
do its reset correct (magnetic sensor, stepping motor, driver on the
PCB, cables, etc.). Repair the defect and start the fixture again.
EFLG
