German Light Products® Control
menus and onboard display
EXO Wash 30 User Manual Rev. B
25
DMX control is disabled when the control menus are active.
Display options
The illuminated LCD display lets you change fixture settings. The display has a battery
backup so that you can change the settings before mains is connected to the fixture.
See Chapter 9 for more details.
Using the
Control / Settings
DMX channel or the fixture’s control panel you can:
Set
display modes
using the
Fixture Settings > Display Mode
option:
-
On
: The display stays on constantly. This setting can be useful when you are
configuring or servicing the fixture.
-
Auto
: The display will automatically switch off after a few seconds even if the fixture
is not receiving a valid control signal or if it has detected an error.
Invert the display
using the
Fixture Settings > Display Orientation
option, so it is easier to
read if the fixture is hanging upside down.
Display Locking
On the
Fixture Settings > Lock
menu, you can configure the display to lock after a
period of time to prevent accidental changes to the options.
You can set a custom lock code using the
Fixture Settings > Lock > Set Passcode
option. If you do not set a custom code, the default code is 0000.
Manual Control
Using the
Manual Control
menu you can set fixed values to the fixture’s control
channels, as if it was in DMX control mode 1. This is useful when testing.
LED PWM frequency
The LEDs in the unit are dimmed using Pulse Width Modulation (PWM) which can
sometimes cause flickering on cameras. The
Fixture Settings > PWM
option allows you
to select different frequencies for the PWM to fix such issues. The higher frequencies
may cause reduced dimming performance.
Fan control
The fixture has internal cooling fans. In a noise critical situation you can slow these
down using the
Fixture Settings > Fan Mode
option. The normal setting is
Regulated
which will adjust the fan speed automatically. If you set the option to
Low
the fan
speed is kept slow but this may result in the fixture overheating and reducing its output.
The fixture has an additional fan near the lens to clear condensation. You can control
how this fan works using the
Fixture Settings > Defog
option.
Fixture information
The
Information
menu in the control panel gives access to items of information from
the fixture’s sensors and memory. You can check temperature sensor readouts, see
total operating hours counters, and see software version number, for example.
Summary of Contents for Fusion EXO Wash 30
Page 1: ...Fusion EXO Wash 30 User Manual Software version V1 0 00...
Page 52: ......
