Sept 7, 2018
Manual
GLOWDOGGIE
®
LEUCHTIE
®
ULTRA Easy Charge
Easily rechargeable via USB charging station
Please read and observe the following safety instructions so that you can
enjoy your new premium LED safety collar for a long time. Please keep
this document in a safe place or visit our
www.glowdoggie.com
for info.
Any questions, at any time, please email [email protected]
Initial Activation
Before using the Glowdoggie®Leuchtie® Easy Charge for the first time you will need to remove the
red battery cap that is located inside the battery pack, on the side furthest from the silver
“Glowdoggie” label ring. You will find an information sticker label taped on this side for your conven-
ience, which you can remove once you have completed the activation.
Opening:
1. Separate the LED tube from the battery pack by
gently
nudging them apart with a slight angular
movement, taking care not to use excessive
force (1). In doing so, hold down on the
silicone sleeve on the battery pack, not the LED
tubing. Once the initial release is made, release
the pressure slightly and gently wiggle out the
end of LED tubing.
2. Remove the red insulation cap (2) and discard
or keep in the welcome pack.
Closing:
3. Insert the LED tube straight into the battery
pack.
Make sure that the contact spring at
the end of the LED tubing goes in straight
and is not bent over in any way.
This is very
important. If the spring is bend over it could
lead to the battery pack overheating immedi-
ately after activation. If this happens, remove
the battery pack and try again.
4. Press the tubing and battery pack firmly togeth-
er, as far as it can go with no gap. Make sure
the silicone sleeve is firmly over the LED tubing.
Page 1: Activation
Page 2-3: Recharging the batteries
Page 4: Troubleshooting
Page 5: Safety information
