Glow Stream NDI, Quick Start Manual, Page: 3 / 21

1
Introduction
Welcome to Glow Stream! With this quick start guide, you’ll get your camer a set up quickly and
ready to use. By the end of the guide, you’ll be sending signal from the camera to your video
switching software, such as vMix or OBS, while also controlling the camera’s movements from
that same software.
One-Cable Simplicity
There are three different technologies that are used in your Glow Stream ™ camera to bring you
1-cable simplicity:
1. NDI® technology from NewTek delivers broadcast-quality video via a local area network
to any connected device.
2. IP VISCA protocol from Sony® sends remote control signals to the camera via a local area
network.
3. Power-over-Ethernet, or PoE, sends power to the camera from the network switch, so a
DC power adapter is not required.
Time Required
5-10 minutes: Someone with a basic understanding of TCP/IP networking and with all required
software already installed.
15-30 minutes: Someone not familiar with networking, or where software must be installed as
part of the setup process.