Thank you for choosing the
GLOCKENKLANG Blue Sky amplifier. You
have purchased an exquisite piece of
equipment, which was designed after the
most modern technical aspects.
Attention!
To activate your additional 3 years
warranty, you should send in the enclosed
warranty card.
Please enter the serial number of your
amplifier and the date of purchase and
send it to:
Glockenklang
Eimterstrasse 147
D-32049 Herford
Germany
or email to: [email protected]
This serves as a measure to ensure
excellent customer service in the
future.
For your safety
Please read the following instructions
carefully. These tips will ensure long and
trouble free operation of your new
GLOCKENKLANG product.
Operational restrictions
Do not operate the amplifier under the
following conditions:
•
In direct sunlight
•
In extremely dirty or dusty places
•
In extremely humid or wet places
•
Around heat emitting appliances
Caution: When rack mounting the
amplifier, make sure to leave adequate
room for ventilation. The unit needs this
ventilation space to adequately exhaust
it´s internally generated heat.
Handling
Do not drop the amp. Do not use
excessive force when activating switches
and dials.
Caution!
For optimum sound use always the
included high-end mains cable!
WARNING!
DO NOT OPEN!
NO USER SERVICEABLE PARTS
INSIDE.
REFER SERVICING TO QUALIFIED
PERSONNEL.
Care
Use a soft, clean and dry cloth only to
clean the amplifier. Do not use aggressive
chemicals to clean the housing. Do not
use compressed air to clean the housing.
You may carefully vacuum the air intake
and exhaust areas from time to time to
remove loose dust accumulation.
Please, keep this User Manual for
future references
General instructions
Your Blue Sky head´s special features:
On the left side you can adjust the
level
of the “DI
-
Out” with a screw
-driver!
"Effect Loop" is a parallel loop with
blending control from 0% till 100% on the
front panel and gain control ±5 dB of
Effect Return. Additional, you can use the
Effect Return either as a mixable Line In or
as a stereo MP3 players input.
It is switched post eq / pre volume-control/
pre-DI out.
The power amp is short circuit, high
temperature and DC voltage protected.
In case of high temperature or DC
current, the red "Protect" LED will come on.
Caution!
Due to safe ventilation, do not remove
the bumpers on the bottom of the amp!
Please ensure adequate ventilation when
rack mounting the amplifier.
Leave a minimum of 5 mm space below
the amplifier. Make sure that the air
entry/discharge vents at the right side of
the housing and the bottom are
unobstructed.
WARNING!
TO REDUCE THE RISC OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.
