Globalstar SmartOne Series, User Manual

Page: 56 / 87

SmartOne Manual Rev 1.5 DOC# 9100-0268-01 p.56
the undesired input state
message.
8 RESERVED 3 Bits (2:0) RESERVED in SmartOne
8
Vibration
triggered message
1
Bit (3) – Value 1 = This
message is being sent because
transmit on change of vibration
state is selected and the
vibration just changed state,
or Undesired Vibration state is
selected and the vibration is
in the undesired state. Value
0 = This message is being
transmitted for a reason other
than the above reasons.
8
Vibration bit. 1
Bit (4) – Value 1 = Unit is in
a state of vibration. Value 0
= Unit is not in a state of
vibration.
8
2D 1
Bit (5) – Value 1 = GPS data
reported is from a 2D fix.
(Only 3 satellites were used in
the fix.) Value 0 = GPS data
reported is from a 3D fix.
8
Motion 1
Bit (6) – Value 1 = Device was
In-Motion when the message was
transmitted. Value 0 = Device
was At-Rest when the message
was transmitted.
8
Fix Confidence
Bit.
1
Bit (7) 0=High confidence in
GPS fix accuracy, 1=Reduced
confidence in GPS fix accuracy.
Table 6 - Undesired Input State Message
Re-Center Message
The Re-Center message is transmitted when Reduced Messaging Mode is
selected and the
SMART
ONE re-centers (automatically sets a new Change of
Location Area). The subtype value of this message is 5. The message
format is shown in table 7.
Byte Number Variable Bits Description
0
Type field 2
Bit (1:0) = 0 = Standard
message type:
0
Battery state 1
Bit (2) 0 = Good battery. 1 =
replace battery.
0
GPS Data Valid 1
Bit (3) 0 = GPS Data valid in
this message. 1 = GPS failed
in this message cycle, ignore
Latitude and Longitude fields.
0
Missed Input State
Change
2
Bit (4) Missed Input 1. A
value of 1 in this bit means
that an input state change of
Input 1 was missed due to the
transmission of a higher
priority message.
Bit (5) = Missed Input 2. A
value of 1 in this bit means
that an input state change of