Globalstar SmartOne Series, User Manual

Page: 22 / 87

SmartOne Manual Rev 1.5 DOC# 9100-0268-01 p.22
Standard Messaging Mode with Motion
The Standard Messaging with Motion Mode is selected for basic tracking
functionality with motion detection capabilities. The user defines the
motion parameters for each application including the Level of
Sensitivity of the vibration sensor, Time to be in a State of Vibration
and Time to be in a State of Lacking Vibration. The
SMART ONE can be set
to report at a different rate, Message Interval while In Motion,
compared to the Location Message Interval.
Reduced Messaging Mode
The Reduced Messaging Mode is ideal for asset management with reduced
messaging capability of the
SMART
ONE. The
SMART
ONE creates a Change of
Location Area of configurable size around the device. If the
SMART
ONE
stays within its Change of Location Area, the number of transmissions
will be reduced.
When the SMART ONE leaves the Change of Location Area and returned to a
State of Lacking Vibration a new Change of Location Area is created
around the
SMART ONE.
Theft Recovery Mode
The Theft Recovery Mode is ideal for assets that are high-risk for
theft. In this Mode, the
SMART ONE creates a Change of Location Area
around its location when powered. The size of the Change of Location
Area is a configurable parameter equal to the distance the device must
move to be considered outside the Change of Location Area. If outside
the Change of Location Area, the
SMART ONE goes into recovery Mode,
transmitting frequent messages until the asset is recovered. The message
interval in recovery Mode is a configurable parameter; however, the
default value is 10 minutes.