Globaljig Super Rotax, User Manual

Page: 10 / 46

INSTRUCTION MANUAL Issue.
08 / 2004
Pag.
8 - 42
5.2 UNPACKING
Cut the plastic straps and remove the four protective wooden angles for crossbeams and
measuring tapes.
Take out the two brackets
, which are useful to fix the bench
with the base of the lift only during transportation.
Photo. 5-05
5.3
HOW TO FIX IT TO THE GROUND
– In order to arrange for the installation area you should refer to Overall Dimensions Drawing (Chapter
14)
– Before setting the equipment on the floor you should ensure that the ground is level and has suitable
bearing capability. It is recommended that it should be able to bear a total weight of 9.000 daN, with a
specific pressure of 0.50 daN/cm² and made of the correct consistency necessary to allow a proper
fixing of the anchoring plugs to the floor.
– The plugs supplied with the equipment are 6 (Ø 20x90 mm), with M12 screws.
– The plugs can be set and fixed only after electrical connection, because you must lift up the bench in
order to reach the floor and work with the drill.
Fig. 5-06
Ð
How to proceed to fix the plugs:
–
Using the holes of the base of the equipment as
a drilling jig, drill the floor with helicoidal point
Ø 20, to a depth of 95 mm..
–
Clean the hole, insert the plugs, tighten the
screws.