Corn Crusher
7
5 Instructions for use
5.1 Assembling the machine
The crusher is delivered in a cardboard box with the dismounted hopper, two sieves
with hole size of 3 mm and 5 mm. The hopper is to be mounted onto the corpus neck.
5.2 Installing the driving unit onto the crusher
Driving unit represents a power source for the machine and is to be installed into a
flange formed in the upper part of the crusher drive. On the bottom side of the complete
flange there is a cylindrical part that is to be inserted into the flange in the crusher drive when
putting the driving unit onto the crusher. The second part for seating the driving unit onto the
gearbox case is a pin located on the upper surface of the crusher drive flange, which is to fall
into the hole in the driving unit flange in order to arrest the position of the driving unit on the
crusher.
5.3 Procedure of driving unit installation
Installing or removing the driving unit, you are advised to approach the machine from
the side of air filter and carburettor control on the engine of the driving unit.
*
Be careful when installing or removing the driving unit or when transporting it to another
machine. The exhaust silencer is hot when in operation.
1. Put the crusher on a firm base. Clean all connecting points for the driving unit and the
inside of the clutch disc.
2. Clutch disc in the crusher drive must not be greasy as a slippage of the centrifugal clutch
might occur that could result in a damage to the clutch lining and to the engine crankshaft
sealing due to high temperature.
3. Grip the driving unit with one of your hands at a holder which is situated on the lower part
of the driving unit flange and with the other hand at an upper joint of the handrail of guiding
handles.
4. Slide the driving unit onto the crusher so that the cylindrical part of the flange completely
falls into the flange on the crusher drive and the pin situated on the upper surface of the
