3
Product Description
Unpacking
Upon receipt, visually inspect for product damage. If damage is evident, notify delivering carrier
immediately and file necessary claims.
Operation
TWS150
1
.
Position the work table near the desired work area.
2.Lock all casters with brake.
3.Adjust the height to the correct
level by star knob adjustment located on the center column and sliding it up or down.
4. Loosen the tilt adjustment
knob under platform .Tilt deck to desired angle and retighten.
5. Place the load on the table.
TWS300
1
.
Position the work table near the desired work area.
2. Lock all casters with brake.
3. Loosen the height adjustment
screw and adjust the work table to the desired height using the handwheel located on
the base
4. Tighten the height adjustment
screw.
5. Adjust the tilt angle of the table
to the desired position using the handwheel directly under the table platform.
6. Place the load on the table.
frame.
CASTER INSTALLATION INSTRUCTIONS
Securely prop up one end of the carts frame high enough for the casters to fit underneath that end.
You will see four caster mounting brackets welded to the bottom of the carts frame, one at each corner.
If you have both swivel and rigid casters, the casters are to be mounted in adjacent pairs, Typically ,the
swivel casters are mounted to the side on which the push handle is located( when applicable),
Determine the proper locations for the casters before you begin
Turn the included machines screws a couple of threads into the two threaded holes in the ends of each
of the caster mounting brackets
To install the casters onto the cart:
Insert either of the short sides of the caster’s top plate into the curled end of the caster mounting
bracket. Raise the other end of the caster’s top plate up into the mounting bracket, and secure it there
by screwing in the machine screws completely. The screws should underneath the caster’s top plate ,
thereby retaining it in the bracket
.
